HP VPN Firewall Appliances High Availability Command Reference

129
Default command level
2: System level
Parameters
number: Specifies the maximum number of Selected ports allowed in an aggregation group.
The following matrix shows the link-aggregation selected-port maximum command and hardware
compatibility and the value range for the number argument on different firewalls and firewall modules:
Hardware
Command
com
p
atibilit
y
Value range
F1000-A-EI/F1000-S-EI Yes 1 to 4
F1000-E No N/A
F5000 Yes 1 to 8
F5000-S/F5000-C No N/A
VPN firewall modules No N/A
20-Gbps VPN firewall modules No N/A
Usage guidelines
Executing this command might cause some of the selected member ports in the aggregation group to
become unselected.
Make sure the maximum number of Selected ports allowed in an aggregation group is the same as that
on the peer.
Examples
# Configure the maximum number of Selected ports allowed as 3 in the aggregation group
corresponding to Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port maximum 3
link-aggregation selected-port minimum
Use link-aggregation selected-port minimum to configure the minimum number of Selected ports in an
aggregation group.
Use undo link-aggregation selected-port minimum to restore the default.
Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
Default
The minimum number of Selected ports in an aggregation group is not specified.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view