HP VPN Firewall Appliances High Availability Command Reference

130
Default command level
2: System level
Parameters
number: Specifies the minimum number of Selected ports in an aggregation group required to bring up
the aggregate interface.
The following matrix shows the link-aggregation selected-port minimum command and hardware
compatibility and the value range for the number argument on different firewalls and firewall modules:
Hardware Command com
p
atibilit
y
Value ran
g
e
F1000-A-EI/F1000-S-EI Yes 1 to 4
F1000-E No N/A
F5000 Yes 1 to 8
F5000-S/F5000-C No N/A
VPN firewall modules No N/A
20-Gbps VPN firewall modules No N/A
Usage guidelines
Executing this command might cause all the member ports in the aggregation group to become
unselected.
Make sure the minimum number of Selected ports in an aggregation group is the same as that on the
peer.
Examples
# Configure the minimum number of Selected ports as 3 in the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
mtu
Use mtu to set the MTU of a Layer 3 aggregate interface or subinterface.
Use undo mtu to restore the default setting.
Syntax
mtu size
undo mtu
Default
The MTU for Layer 3 aggregate interfaces and subinterfaces is 1500 bytes.
Views
Layer 3 aggregate interface view, Layer 3 aggregate subinterface view
Default command level
2: System level