HP VPN Firewall Appliances High Availability Command Reference

137
Fla
g
Descri
p
tion
P---PULLED The interface board where the interface is located is removed.
Table 36 Load balancing states
State Descri
p
tion
WAKE
The active interface is transiting from the working state to the non-working state. The
standby interface is working in the load balancing state to transmit data together with
the active interface.
TO-HYPNOTIZE
The standby interface is transiting from the working state to the non-working state after
the traffic size decreases below the lower backup load balancing threshold. In this
state, the standby interface is still working.
TO-WAKE
The standby interface is transiting from the non-working state to the working state after
the traffic size increases above the upper backup load balancing threshold.
Null State other than the above three. At this time, the value for the loadstate field is null.
standby bandwidth
Use standby bandwidth to configure the active interface bandwidth used for setting the thresholds.
Use undo standby bandwidth to restore the default.
Syntax
standby bandwidth size
undo standby bandwidth
Default
The available bandwidth used for setting the thresholds is 0 kbps.
Views
Interface view
Default command level
2: System level
Parameters
size: Specifies the active interface bandwidth used for setting the thresholds, in the range of 0 to
4000000 kbps.
Usage guidelines
Use this command after standby interfaces are specified.
If the available bandwidth used for setting the thresholds is 0 kbps (the default value), the interface
backup module automatically obtains the actual bandwidth of the active interface to set the thresholds.
If the available bandwidth configured for setting the thresholds exceeds the actual bandwidth on the
interface, load balancing does not take effect.
Examples
# Configure the available bandwidth used for setting the thresholds on active interface GigabitEthernet
0/1 for load balancing as 10000 kbps.