HP VPN Firewall Appliances High Availability Command Reference

140
standby timer delay
Use standby timer delay to set switchover delays on the interface.
Use undo standby timer delay to restore the default.
Syntax
standby timer delay enable-delay disable-delay
undo standby timer delay
Default
Switchover delays on the active and standby interfaces are 0, indicating immediate switchover without
any delay.
Views
Interface view
Default command level
2: System level
Parameters
enable-delay: Specifies switchover delay from the active interface to the standby interface. The value for
this argument is in the range of 0 to 65535 seconds.
disable-delay: Specifies switchover delay from the standby interface to the active interface. The value for
this argument is in the range of 0 to 65535 seconds.
Usage guidelines
This command sets the delay timer for a standby interface to startup when the active interface is down,
and the delay timer for a standby interface to be disabled after the active interface is recovered.
This command must be executed after standby interfaces are specified.
Examples
# Configure interface GigabitEthernet 0/2 to use interface GigabitEthernet 0/1 for backup, and to
experience 10 seconds of delay before switchover.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] standby interface gigabitethernet 0/2
[Sysname-GigabitEthernet0/1] standby timer delay 10 10
Related commands
standby interface
standby timer flow-check
Use standby timer flow-check to configure the interval for checking the traffic size on the active interface.
Use undo standby timer flow-check to restore the default.
Syntax
standby timer flow-check interval
undo standby timer flow-check