HP VPN Firewall Appliances High Availability Command Reference
12
[Sysname-GigabitEthernet0/1] vrrp vrid 1 virtual-ip 10.1.1.1
[Sysname-GigabitEthernet0/1] vrrp vrid 1 timer advertise 5
Related commands
display vrrp
vrrp vrid track
Use vrrp vrid track to associate a VRRP group with a track entry and control master switchover in the
VRRP group in response to changes (such as uplink state changes) detected by the track entry.
Use undo vrrp vrid track to remove the association between a VRRP group and a track entry. If no track
entry is specified, the association between the VRRP group and any track entry is removed.
Syntax
vrrp vrid virtual-router-id track track-entry-number [ reduced priority-reduced | switchover ]
undo vrrp vrid virtual-router-id track [ track-entry-number ]
Default
A VRRP group is not associated with any track entry.
Views
Interface view
Default command level
2: System level
Parameters
virtual-router-id: Specifies a VRRP group number, which ranges from 1 to 255.
track track-entry-number: Specifies a track entry. The track-entry-number argument ranges from 1 to
1024.
reduced priority-reduced: Reduces the priority of the router in the VRRP group by a specific value when
the state of the specified track entry changes to the negative state. The priority-reduced argument ranges
from 1 to 255.
switchover: Enables the router in backup state to take over as the master immediately after the specified
track entry changes to the negative state.
Usage guidelines
When the associated track entry changes to the negative state, the priority of the router in the VRRP group
decreases by a specified value, or the router immediately takes over as the master if it is a backup,
depending on your configuration.
When the track entry changes from negative to positive or invalid, the router automatically restores its
priority.
You must create the VRRP group and assign a virtual IP address to it before you can associate it with any
track entry.
The vrrp vrid track command cannot take effect on an IP address owner. If you have configured the
command on an IP address owner, the configuration takes effect after the router changes to be a non IP
address owner.