HP VPN Firewall Appliances High Availability Configuration Guide

98
Figure 49 Checking the status of Collaboration Group 1's member ports
Configuring a collaboration group at the CLI
Configuring a collaboration group
Perform the following operation on multiple interfaces to add them to a collaboration group.
An interface can belong to only one collaboration group. A collaboration group can have at most eight
interfaces.
When a device is connected to another device through multiple ports, do not assign these ports to the
same collaboration group. Otherwise, when one port goes down, its peer port on the remote device
might be set to the linkgroup-down state. In that case, all the ports might fail to be brought up.
To configure a collaboration group:
Ste
p
Command Remarks
Enter system view. system-view N/A
Enter interface view. interface interface-type interface-number N/A
Add the interface to the
specified collaboration
group.
link-group link-group-number
By default, an interface does
not belong to any
collaboration group.
Displaying and maintaining collaboration group
Task Command Remarks
Display the collaboration
group information
display link-group [ number
link-group-number | brief ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.
