HP VPN Firewall Appliances High Availability Configuration Guide

133
# Stop the TCP operation after a period of time.
[FirewallA] undo nqa schedule admin test1
# Display the results of the TCP operation.
[FirewallA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2011-11-22 10:27:25.1
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history records of the TCP operation.
[FirewallA] display nqa history admin test1
NQA entry (admin admin, tag test1) history record(s):
Index Response Status Time
1 13 Succeeded 2011-11-22 10:27:25.1
The output shows that Firewall A uses 13 milliseconds to establish a TCP connection to port 9000
on the NQA server.
UDP echo operation configuration example
Network requirements
As shown in Figure 61, configure a UDP echo operation to test the round-trip time between Firewall A and
Firewall B. The destination port number is 8000.
Figure 61 Network diagram
Configuration procedure
1. Assign each interface an IP address. (Details not shown.)
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure Firewall B:
# Enable the NQA server, and configure a listening service to listen on the IP address 10.2.2.2
and UDP port 8000.