HP VPN Firewall Appliances High Availability Configuration Guide

138
# Enable the saving of history records.
[Firewall-nqa-admin-test1-dlsw] history-record enable
[Firewall-nqa-admin-test1-dlsw] quit
# Start the DLSw operation.
[Firewall] nqa schedule admin test1 start-time now lifetime forever
# Stop the DLSw operation after a period of time.
[Firewall] undo nqa schedule admin test1
# Display the results of the DLSw operation.
[Firewall] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Destination IP address: 10.2.2.2
Send operation times: 1 Receive response times: 1
Min/Max/Average round trip time: 19/19/19
Square-Sum of round trip time: 361
Last succeeded probe time: 2011-11-22 10:40:27.7
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history records of the DLSw operation.
[Firewall] display nqa history admin test1
NQA entry (admin admin, tag test1) history record(s):
Index Response Status Time
1 19 Succeeded 2011-11-22 10:40:27.7
The output shows that the response time of the DLSw device is 19 milliseconds.
NQA collaboration configuration example
Network requirements
As shown in Figure 64, configure a static route to Device B with Device A as the next hop on Firewall.
Associate the static route, a track entry, and an NQA operation to monitor the state of the static route.