HP VPN Firewall Appliances High Availability Configuration Guide

171
2. Configuration procedure
a. Configure Firewall A:
# Create Layer 3 aggregate interface Route-Aggregation 1, configure it to perform load
sharing based on source IP address, and configure an IP address and subnet mask for the
aggregate interface.
<FirewallA> system-view
[FirewallA] interface route-aggregation 1
[FirewallA-Route-Aggregation1] link-aggregation load-sharing mode source-ip
[FirewallA-Route-Aggregation1] ip address 192.168.1.1 24
[FirewallA-Route-Aggregation1] quit
# Assign Layer 3 interfaces GigabitEthernet 0/1 and GigabitEthernet 0/2 to aggregation
group 1.
[FirewallA] interface gigabitethernet 0/1
[FirewallA-GigabitEthernet0/1] port link-aggregation group 1
[FirewallA-GigabitEthernet0/1] quit
[FirewallA] interface gigabitethernet 0/2
[FirewallA-GigabitEthernet0/2] port link-aggregation group 1
[FirewallA-GigabitEthernet0/2] quit
# Create Layer 3 aggregate interface Route-Aggregation 2, configure its link aggregation
group to perform load sharing based on destination IP address, and configure an IP address
and subnet mask for the aggregate interface.
[FirewallA] interface route-aggregation 2
[FirewallA-Route-Aggregation2] link-aggregation load-sharing mode destination-ip
[FirewallA-Route-Aggregation2] ip address 192.168.2.1 24
[FirewallA-Route-Aggregation2] quit
# Assign Layer 3 interfaces GigabitEthernet 0/3 and GigabitEthernet 0/4 to aggregation
group 2.
[FirewallA] interface gigabitethernet 0/3
[FirewallA-GigabitEthernet0/3] port link-aggregation group 2
[FirewallA-GigabitEthernet0/3] quit
[FirewallA] interface gigabitethernet 0/4
[FirewallA-GigabitEthernet0/4] port link-aggregation group 2
[FirewallA-GigabitEthernet0/4] quit
b. Configure Firewall B in the same way Firewall A is configured. (Details not shown.)
3. Verify the configuration
# Display summary information about all aggregation groups on Firewall A.
[FirewallA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG Partner ID Select Unselect Share
Interface Mode Ports Ports Type
-------------------------------------------------------------------------------
RAGG1 S none 2 0 Shar