HP VPN Firewall Appliances High Availability Configuration Guide

195
Item Descri
p
tion
Source Port
Source port that sends detection packets for SIP health
monitoring.
Version
Version and read-only community name used in SNMP health
monitoring. Read-only community name takes effect on
SNMPv1 and SNMPv2c.
By default, the version is v1, v2c, and v3, and the read-only
community name is public.
The parameters are
available only on the
page for setting SNMP
health monitoring
parameters.
Read-only
Community Name
Destination IP
Destination IP address for health monitoring.
If this parameter is not specified, the IP address of the real service is adopted.
Destination Port
Destination port number for health monitoring.
IMPORTANT:
• ARP health monitoring and ICMP health monitoring do not support this parameter.
• If this parameter is 0 (not specified), the port number of the real service is used for
heath monitoring (except SIP health monitoring).
• HP recommends that you specify a non-zero destination port number for health
monitoring based on the network environment.
• For UDPNORMAL health monitoring, if both this parameter and the port number of
the real service are 0, the health monitoring fails.
Creating a real service group
1. Select High Reliability > Load Balance > Server Load Balance from the navigation tree.
The Real Service Group tab appears.
Figure 99 Real service group
If you click the Number of Real Services link for a real service group, the Real Service tab appears,
displaying information about the real services that belong to the real service group.
2. Click Add.
The real service group configuration page appears.