HP VPN Firewall Appliances High Availability Configuration Guide

48
# Set the priority of Firewall B in VRRP group 2 to 110, which is higher than that of Firewall A (100),
so that Firewall B can become the master in VRRP group 2.
[FirewallB-GigabitEthernet0/1] vrrp ipv6 vrid 2 priority 110
3. Verify the configuration:
To verify your configuration, use the display vrrp ipv6 verbose command.
# Display the detailed information about the VRRP group on Firewall A.
[FirewallA-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 2
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 0
Auth Type : None
Virtual IP : FE80::10
1::10
Virtual MAC : 0000-5e00-0201
Master IP : FE80::1
Interface GigabitEthernet0/1
VRID : 2 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Become Master : 2200ms left
Auth Type : None
Virtual IP : FE80::20
1::20
Master IP : FE80::2
# Display the detailed information about the VRRP group on Firewall B.
[RouterB-GigabitEthernet0/1] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 2
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 100
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 0
Become Master : 2200ms left
Auth Type : None
Virtual IP : FE80::10
1::10