HP VPN Firewall Appliances NAT and ALG Command Reference

27
GigabitEthernet0/1
Table 10 Command output
Field Descri
p
tion
Total Sessions Total number of sessions.
Expired Sessions Number of expired sessions.
Hits Number of times that a packet matches a NAT-PT session.
Misses Number of times that a packet matches no NAT-PT sessions.
Total Address Mapping Number of static and dynamic mappings.
Total V6Server Mappings Number of V6Server mappings (address/port mappings).
Enabled Interfaces NAT-PT enabled interfaces.
Related commands
reset natpt statistics
natpt address-group
Use natpt address-group to configure a NAT-PT address pool.
Use undo natpt address-group to remove the specified NAT-PT address pool.
Syntax
natpt address-group group-number start-ipv4-address end-ipv4-address
undo natpt address-group group-number
Views
System view
Default command level
2: System level
Parameters
group-number: Specifies the number of an address pool, in the range of 1 to 32.
start-ipv4-address: Specifies the start IPv4 address in a pool.
end-ipv4-address: Specifies the end IPv4 address in a pool.
Usage guidelines
If start-ipv4-address is the same as end-ipv4-address, only one address is available in the address pool.
The execution of the undo natpt address-group command might affect some dynamic NAT-PT mappings.
A NAT-PT address pool and an IPv4 NAT address pool do not share any address.
When there is only one address in the NAT-PT address pool, the address applies to only NAPT-PT. When
there is more than one address in the NAT-PT address pool, the end IPv4 address is reserved for NAPT-PT.
The number of addresses used for dynamic NAT-PT mapping is the number of configured addresses
minus 1.
You cannot configure a NAT-PT address pool and an AFT address pool with the same number at the
same time.