HP VPN Firewall Appliances Network Management Command Reference

978
Usage guidelines
If an (S, G) is marked SPT, this (S, G) entry uses an IPv6 unicast route.
Examples
# Display information about all IPv6 unicast routes that IPv6 PIM uses.
<Sysname> display pim ipv6 claimed-route
RPF information about: 2001::2
RPF interface: GigabitEthernet0/1, RPF neighbor: FE80::A01:100:1
Referenced prefix/prefix length: 2001::/64
Referenced route type: igp
RPF-route selecting rule: preference-preferred
The (S, G) or (*, G) list dependent on this route entry
(2001::2, FF03::101)
Table 225 Command output
Field Descri
p
tion
RPF information about: 2001::2
Information of the RPF route to IPv6 multicast source
2001::2.
RPF interface RPF interface type and number.
RPF neighbor IPv6 address of the RPF neighbor.
Referenced prefix/prefix length Address/mask of the reference route.
Referenced route type
Type of the referenced route:
• igp—IGP IPv6 unicast route.
• egp—EGP IPv6 unicast route.
• unicast (direct)—Direct IPv6 unicast route.
• unicast—Other IPv6 unicast route (such as IPv6
static unicast route).
• mbgp—IPv6 MBGP route.
RPF-route selecting rule Rule of RPF route selection.
The (S,G) or (*,G) list dependent on this route entry (S, G) or (*, G) entry list dependent on this RPF route.
display pim ipv6 control-message counters
Use display pim ipv6 control-message counters to display the statistics for IPv6 PIM control messages.
Syntax
display pim ipv6 control-message counters [ message-type { probe | register | register-stop } |
[ interface interface-type interface-number | message-type { assert | bsr | crp | graft | graft-ack | hello
| join-prune | state-refresh } ] * ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level