HP VPN Firewall Appliances Network Management Command Reference

991
When you use the undo embedded-rp command without specifying acl6-number, the embedded RP
feature is disabled for all the IPv6 multicast groups. If you specify acl6-number, this command will restore
the default.
Examples
# Enable embedded RP for only those IPv6 multicast groups in the address scope FF7E:140:20::101/64.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff7e:140:20::101 64
[Sysname-acl6-basic-2000] quit
[Sysname] pim ipv6
[Sysname-pim6] embedded-rp 2000
hello-option dr-priority (IPv6 PIM view)
Use hello-option dr-priority to configure the global value of the router priority for DR election.
Use undo hello-option dr-priority to restore the default.
Syntax
hello-option dr-priority priority
undo hello-option dr-priority
Default
The router priority for DR election is 1.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
priority: Specifies a router priority for DR election, in the range of 0 to 4294967295. A larger value
indicates a higher priority.
Examples
# Set the router priority for DR election to 3.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] hello-option dr-priority 3
Related commands
pim ipv6 hello-option dr-priority
hello-option holdtime (IPv6 PIM view)
Use hello-option holdtime to configure the IPv6 PIM neighbor timeout timer.
Use undo hello-option holdtime to restore the default.