HP VPN Firewall Appliances Network Management Command Reference

1007
Examples
# Set the hello interval to 40 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim ipv6 timer hello 40
Related commands
timer hello
pim ipv6 timer join-prune
Use pim ipv6 timer join-prune to configure the interval at which join/prune messages are sent on the
current interface.
Use undo pim ipv6 timer join-prune to restore the default.
Syntax
pim ipv6 timer join-prune interval
undo pim ipv6 timer join-prune
Default
The join/prune interval is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a join/prune interval in seconds. The value ranges from 1 to 2147483647.
Examples
# Set the join/prune interval to 80 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim ipv6 timer join-prune 80
Related commands
timer join-prune
pim ipv6 triggered-hello-delay
Use pim ipv6 triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim ipv6 triggered-hello-delay to restore the default.
Syntax
pim ipv6 triggered-hello-delay interval
undo pim ipv6 triggered-hello-delay