HP VPN Firewall Appliances Network Management Command Reference

1008
Default
The maximum delay between hello messages is 5 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies the maximum delay in seconds between hello messages. The value ranges from 1 to
60.
Examples
# Set the maximum delay between hello messages to 3 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim ipv6 triggered-hello-delay 3
probe-interval (IPv6 PIM view)
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.
Syntax
probe-interval interval
undo probe-interval
Default
The register probe time is 5 seconds.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a register probe time in seconds. The value ranges from 1 to 1799.
Examples
# Set the register probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
Related commands
register-suppression-timeout