HP VPN Firewall Appliances Network Management Command Reference

1009
prune delay (IPv6 PIM view)
Use prune delay to set the prune delay timer (namely, the time that the device waits between receiving
a prune message and taking a prune action).
Use undo prune delay to restore the default.
Syntax
prune delay interval
undo prune delay
Default
No prune delay timer is set.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a prune delay timer in seconds, in the range 1 to 128.
Examples
# Set the prune delay timer to 75 seconds on the public network.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] prune delay 75
register-policy (IPv6 PIM view)
Use register-policy to configure an IPv6 ACL rule to filter register messages.
Use undo register-policy to remove the configured register filtering rule.
Syntax
register-policy acl6-number
undo register-policy
Default
No register filtering rule is configured.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
acl6-number: Specifies an advanced IPv6 ACL, in the range of 3000 to 3999. The RP can accept only
register messages that match the permit statement of the IPv6 ACL.