HP VPN Firewall Appliances Network Management Command Reference

1010
Examples
# Configure a register filtering policy on the RP so that the RP can accept only those register messages
from IPv6 multicast sources on the 3:1::/64 subnet for IPv6 multicast groups on the FF0E:13::/64 subnet.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule permit ipv6 source 3:1:: 64 destination ff0e:13:: 64
[Sysname-acl6-adv-3000] quit
[Sysname] pim ipv6
[Sysname-pim6] register-policy 3000
Related commands
register-suppression-timeout
register-suppression-timeout (IPv6 PIM view)
Use register-suppression-timeout to configure the register suppression time.
Use undo register-suppression-timeout to restore the default.
Syntax
register-suppression-timeout interval
undo register-suppression-timeout
Default
The register suppression time is 60 seconds.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a register suppression time in seconds, in the range of 1 to 65535.
Examples
# Set the register suppression time to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-suppression-timeout 70
Related commands
• probe-interval
• register-policy
register-whole-checksum (IPv6 PIM view)
Use register-whole-checksum to configure the router to calculate the checksum based on the entire
register message.
Use undo register-whole-checksum to restore the default.