HP VPN Firewall Appliances Network Management Command Reference

1011
Syntax
register-whole-checksum
undo register-whole-checksum
Default
The checksum is calculated based only on the header in the register message.
Views
IPv6 PIM view
Default command level
2: System level
Examples
# Configure the router to calculate the checksum based on the entire register message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] register-whole-checksum
Related commands
• register-policy
• register-suppression-timeout
reset pim ipv6 control-message counters
Use reset pim ipv6 control-message counters to reset IPv6 PIM control message counters.
Syntax
reset pim ipv6 control-message counters [ interface interface-type interface-number ]
Views
User view
Default command level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify an
interface, this command clears the statistics for the IPv6 PIM control messages on all interfaces.
Examples
# Reset IPv6 PIM control message counters on all interfaces.
<Sysname> reset pim ipv6 control-message counters
source-lifetime (IPv6 PIM view)
Use source-lifetime to configure the IPv6 multicast source lifetime.
Use undo source-lifetime to restore the default.