HP VPN Firewall Appliances Network Management Command Reference

1016
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70
Related commands
• pim ipv6 state-refresh-capable
• state-refresh-hoplimit
• state-refresh-rate-limit
state-refresh-rate-limit (IPv6 PIM view)
Use state-refresh-rate-limit to configure the time that the device waits before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit interval
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it receives a new state refresh message.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a time that the device waits before receiving a new refresh message. The value ranges
from 1 to 65535 seconds.
Examples
# Configure the device to wait 45 seconds before it receives a new state refresh message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-rate-limit 45
Related commands
• pim ipv6 state-refresh-capable
• state-refresh-hoplimit
• state-refresh-interval
static-rp (IPv6 PIM view)
Use static-rp to configure a static RP.
Use undo static-rp to configure a static RP.