HP VPN Firewall Appliances Network Management Command Reference

1079
IPv4 routing policy commands
apply ip-address next-hop
Use apply ip-address next-hop to set a next hop for IPv4 routing information.
Use undo apply ip-address next-hop to remove the clause configuration.
Syntax
apply ip-address next-hop ip-address
undo apply ip-address next-hop
Default
No next hop is set for IPv4 routing information.
Views
Routing policy view
Default command level
2: System level
Parameters
ip-address: IP address of the next hop.
Usage guidelines
This command cannot set a next hop for redistributed routes.
Examples
# Configure node 10 in permit mode of routing policy policy1 to set next hop 193.1.1.8 for routes
matching AS path list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply ip-address next-hop 193.1.1.8
display ip ip-prefix
Use display ip ip-prefix to display IPv4 prefix list statistics.
Syntax
display ip ip-prefix [ ip-prefix-name ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
ip-prefix-name: Specifies an IP prefix list by its name, a string of 1 to 19 characters.