HP VPN Firewall Appliances Network Management Command Reference

103
Syntax
stp no-agreement-check
undo stp no-agreement-check
Default
No Agreement Check is disabled.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Usage guidelines
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
This feature takes effect only after you enable it on the root port.
Examples
# Enable No Agreement Check on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] stp no-agreement-check
stp pathcost-standard
Use stp pathcost-standard to specify a standard for the device to use when calculating the default path
costs for ports.
Use undo stp pathcost-standard to restore the default.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
Default
The default standard is legacy.
Views
System view
Default command level
2: System level
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d-1998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.