HP VPN Firewall Appliances Network Management Command Reference

238
Parameters
ip-range startIP to endIP: Specifies the IP address range for which local proxy ARP is enabled. The start
IP address must be lower than or equal to the end IP address.
Usage guidelines
Only one IP address range can be specified by using the ip-range keyword on an interface.
Examples
# Enable local proxy ARP on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] local-proxy-arp enable
# Enable local proxy ARP on GigabitEthernet 0/1 for a specific IP address range.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] local-proxy-arp enable ip-range 1.1.1.1 to 1.1.1.20
Related commands
display local-proxy-arp
proxy-arp enable
Use proxy-arp enable to enable proxy ARP.
Use undo proxy-arp enable to disable proxy ARP.
Syntax
proxy-arp enable
undo proxy-arp enable
Default
Proxy ARP is disabled.
Views
VLAN interface view, Layer 3 Ethernet interface view, Layer 3 Ethernet subinterface view, Layer 3
aggregate interface view, Layer 3 aggregate subinterface view
Default command level
2: System level
Examples
# Enable proxy ARP on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] proxy-arp enable
Related commands
display proxy-arp