HP VPN Firewall Appliances Network Management Command Reference

288
import-route (RIP view)
Use import-route to enable route redistribution from another routing protocol.
Use undo import-route to disable route redistribution.
Syntax
import-route protocol [ process-id | all-processes | allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
undo import-route protocol [ process-id | all-processes ]
Default
RIP does not redistribute routes from any other routing protocol.
Views
RIP view
Default command level
2: System level
Parameters
protocol: Specifies a routing protocol from which to redistribute routes. It can be bgp, direct, isis, ospf,
rip, or static.
The following matrix shows the values for the protocol argument on different firewalls and firewall
modules:
Hardware Protocol ke
y
words
F1000-A-EI/F1000-S-EI bgp, direct, ospf, rip, and static
F1000-E bgp, direct, ospf, rip, and static
F5000 bgp, direct, isis, ospf, rip, and static
F5000-S/F5000-C bgp, direct, ospf, rip, and static
VPN firewall modules bgp, direct, ospf, rip, and static
20-Gbps VPN firewall modules bgp, direct, ospf, rip, and static
process-id: Specifies a process by its ID, in the range of 1 to 65535. The default is 1. This argument is
available only when the protocol is isis, rip, or ospf.
all-processes: Enables route redistribution from all the processes of the specified protocol. This keyword
takes effect only when the protocol is isis, rip, or ospf.
allow-ibgp: Allows redistribution of IBGP routes. This keyword is available when the protocol argument
is set to bgp.
cost: Specifies a cost for redistributed routes, in the range of 0 to 16. If no cost is specified, the default
cost specified by the default cost command applies.
tag: Specifies a tag for marking redistributed routes, in the range of 0 to 65535. The default is 0.
route-policy route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63
characters.