HP VPN Firewall Appliances Network Management Command Reference

289
Usage guidelines
The import-route bgp command only redistributes EBGP routes. The import-route bgp allow-ibgp
command additionally redistributes IBGP routes and might cause routing loops. Therefore, use it with
caution.
This command redistributes only active routes. To view route state information, use the display ip
routing-table protocol command.
The undo import-route protocol all-processes command removes only the configuration made by the
import-route protocol all-processes command, instead of the configuration made by the import-route
protocol process-id command.
Examples
# Redistribute static routes into RIP, and set the cost for redistributed routes to 4.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] import-route static cost 4
# Configure a default cost of 3 for redistributed routes.
[Sysname-rip-1] default cost 3
# Redistribute OSPF routes with the cost being the default cost.
[Sysname-rip-1] import-route ospf
Related commands
default cost
maximum load-balancing (RIP view)
Use maximum load-balancing to specify the maximum number of equal-cost multi-path (ECMP) routes for
load balancing.
Use undo maximum load-balancing to restore the default.
Syntax
maximum load-balancing number
undo maximum load-balancing
Default
The maximum number of ECMP routes depends on the device model.
Views
RIP view
Default command level
2: System level
Parameters
number: Specifies the maximum number of ECMP routes.
The following matrix shows the value range and default values for the number argument on different
firewalls and firewall modules: