HP VPN Firewall Appliances Network Management Command Reference

290
Hardware Value ran
g
e Default value
F1000-A-EI/F1000-S-EI 1 to 8 8
F1000-E 1 to 8 8
F5000 1 to 16 16
F5000-S/F5000-C 1 to 8 8
VPN firewall modules 1 to 8 8
20-Gbps VPN firewall modules 1 to 8 8
Examples
# Specify the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1] maximum load-balancing 2
network
Use network to enable RIP on an interface attached to a specified network.
Use undo network to disable RIP on an interface attached to a specified network.
Syntax
network network-address
undo network network-address
Default
RIP is disabled on an interface.
Views
RIP view
Default command level
2: System level
Parameters
network-address: Specifies a subnet address where an interface resides.
Usage guidelines
RIP runs only on an interfaces attached to the specified network. An interface not on the specified
network does not receive or send routes, or advertise its direct routes.
For a single process, the network 0.0.0.0 command can enable RIP on all interfaces. If multiple RIP
processes exist, the command is not applicable.
If a physical interface is attached to multiple networks, you cannot advertise these networks in different
RIP processes.
Examples
# Enable RIP on the interface attached to the network 129.102.0.0.
<Sysname> system-view
[Sysname] rip 100