HP VPN Firewall Appliances Network Management Command Reference

349
Views
OSPF view
Default command level
2: System level
Parameters
interval: Specifies the LSA arrival interval in milliseconds, in the range of 0 to 60000.
Usage guidelines
If an LSA that has the same LSA type, LS ID, originating router ID with the previous LSA is received within
the interval, the LSA is discarded. This feature helps protect resources from being over consumed due to
frequent network changes.
The interval set with the lsa-arrival-interval command should be smaller or equal to the initial interval set
with the lsa-generation-interval command.
Examples
# Set the LSA arrival interval to 200 milliseconds.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] lsa-arrival-interval 200
Related commands
lsa-generation-interval
lsa-generation-interval
Use lsa-generation-interval to configure the OSPF LSA generation interval.
Use undo lsa-generation-interval to restore the default.
Syntax
lsa-generation-interval maximum-interval [ initial-interval [ incremental-interval ] ]
undo lsa-generation-interval
Default
The maximum interval is 5 seconds, the minimum interval is 0 milliseconds, and the incremental interval
is 5000 milliseconds.
Views
OSPF view
Default command level
2: System level
Parameters
maximum-interval: Specifies the maximum LSA generation interval in the range of 1 to 60 seconds. The
default is 5 seconds.
initial-interval: Specifies the minimum LSA generation interval, in the range of 10 to 60000 milliseconds.
The default is 0 milliseconds.