HP VPN Firewall Appliances Network Management Command Reference

351
Use undo maximum load-balancing to restore the default.
Syntax
maximum load-balancing maximum
undo maximum load-balancing
Views
OSPF view
Default command level
2: System level
Parameters
maximum: Specifies the maximum number of ECMP routes. No ECMP load balancing is available when
the number is set to 1.
The following matrix shows the value range and default values for the maximum argument on different
firewalls and firewall modules:
Hardware Value ran
g
e Default value
F1000-A-EI/F1000-S-EI 1 to 8 8
F1000-E 1 to 8 8
F5000 1 to 16 16
F5000-S/F5000-C 1 to 8 8
VPN firewall modules 1 to 8 8
20-Gbps VPN firewall modules 1 to 8 8
Examples
# Specify the maximum number of ECMP routes as 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] maximum load-balancing 2
network (OSPF area view)
Use network to enable OSPF on the interface attached to the specified network in the area.
Use undo network to disable OSPF for the interface attached to the specified network in the area.
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
Default
An interface neither belongs to any area nor runs OSPF.
Views
OSPF area view