HP VPN Firewall Appliances Network Management Command Reference

361
Views
System view
Default command level
2: System level
Examples
# Enable OSPF to give priority to receiving and processing hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment
ospf timer dead
Use ospf timer dead to set the neighbor dead interval.
Use undo ospf timer dead to restore the default.
Syntax
ospf timer dead seconds
undo ospf timer dead
Default
The dead interval is 40 seconds for broadcast and P2P interfaces and is 120 seconds for P2MP and
NBMA interfaces.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the dead interval in seconds, in the range of 1 to 2147483647.
Usage guidelines
If an interface receives no hello packet from a neighbor within the dead interval, the interface considers
the neighbor down. The dead interval on an interface is at least four times the hello interval. Routers
attached to the same segment must have the same dead interval.
Examples
# Configure the dead interval for GigabitEthernet 0/1 as 60 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ospf timer dead 60
Related commands
ospf timer hello
ospf timer hello
Use ospf timer hello to set the hello interval on an interface.