HP VPN Firewall Appliances Network Management Command Reference

417
• For cost styles wide and wide-compatible, the cost ranges from 1 to 16777215. When the cost
value is 16777215, the neighbor TLV generated on the link can only be used to transmit relevant TE
information, but cannot be used to calculate routes.
level-1: Applies the cost to Level-1.
level-2: Applies the cost to Level-2.
Usage guidelines
If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.
Configure a proper IS-IS cost for each interface to ensure correct route calculation.
Examples
# Configure the Level-2 IS-IS cost as 5 for GigabitEthernet 1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/1
[Sysname-GigabitEthernet1/1] isis cost 5 level-2
Relate commands
circuit-cost
isis dis-name
NOTE:
• This command is not supported on a point-to-point interface.
• This command is not available in loopback interface view.
Use isis dis-name to configure a name for a DIS to represent the pseudo node on a broadcast network.
Use undo isis dis-name to remove the configuration.
Syntax
isis dis-name symbolic-name
undo isis dis-name
Default
No name is configured for the DIS.
Views
Interface view
Default command level
2: System level
Parameters
symbolic-name: Specifies a DIS name, a string of 1 to 64 characters.
Usage guidelines
This command takes effect only on a router that must have dynamic system ID to host name mapping
enabled.