HP VPN Firewall Appliances Network Management Command Reference

20
The following matrix shows the jumboframe enable command and hardware compatibility:
Hardware Com
p
atibilit
y
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 No
F5000-S/F5000-C No
VPN firewall modules
You can directly configure jumboframe enable in
Ten-GigabitEthernet interface view.
The value range for the value argument is 1550 to 9216.
20-Gbps VPN firewall modules
Configure jumboframe enable in system view first. After
rebooting the device, configure jumboframe enable in
Ten-GigabitEthernet interface view.
The value range for the value argument is 1550 to 9216.
Examples
• On 20-Gbps VPN firewall modules:
# Allow jumbo frames to pass through Layer 2 Ethernet interfaces.
<Sysname> system-view
[Sysname] jumboframe enable
# After rebooting the device, allow jumbo frames to pass through Layer 2 Ethernet interface
Ten-GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 0/1
[Sysname-Ten-GigabitEthernet0/1] jumboframe enable
• On VPN firewall modules:
# Allow jumbo frames to pass through Layer 2 Ethernet interface Ten-GigabitEthernet 0/0.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 0/0
[Sysname-Ten-GigabitEthernet0/0] jumboframe enable
loopback
Use loopback to enable loopback testing on an Ethernet interface.
Use undo loopback to disable loopback testing on an Ethernet interface.
Syntax
loopback { external | internal }
undo loopback
Default
Loopback testing is disabled on Ethernet interfaces.
Views
Layer 3 Ethernet interface view