HP VPN Firewall Appliances Network Management Command Reference

453
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] dampening 15 15 1000 2000 10000
Related commands
• display bgp routing-table dampened
• display bgp routing-table dampening parameter
• display bgp routing-table flap-info
• reset bgp dampening
• reset bgp flap-info
default ipv4-unicast
Use default ipv4-unicast to enable the default use of IPv4 unicast address family for the peers that are
established using the peer as-number command.
Use undo default ipv4-unicast to disable the default use of IPv4 unicast address family for the peers that
are established using the peer as-number command.
Syntax
default ipv4-unicast
undo default ipv4-unicast
Default
The use of IPv4 unicast address family is enabled.
Views
BGP view
Default command level
2: System level
Usage guidelines
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that are
established after it is executed.
The default ipv4-unicast or undo default ipv4-unicast command applies to only BGP peers that are
established using the peer as-number command.
After executing the undo default ipv4-unicast command, you can use the peer enable command to
enable the use of IPv4 address family for a peer.
Examples
# Enable the default use of IPv4 unicast address family for the peers that are established using the peer
as-number command.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default ipv4-unicast