HP VPN Firewall Appliances Network Management Command Reference

561
RPF interface: GigabitEthernet0/1, RPF neighbor: 10.1.1.1
Referenced route/mask: 192.168.1.0/24
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 119 Command output
Field Descri
p
tion
RPF information about source
192.168.1.55
Information of the RPF path to multicast source 192.168.1.55.
RPF interface
RPF interface. If the RPF interface is an interface in another VPN, the
VPN name is displayed.
RPF neighbor IP address of the RPF neighbor.
Referenced route/mask Referenced route and its mask length.
Referenced route type
Type of the referenced route, which can be any of the following:
• igp—Unicast route (IGP).
• egp—Unicast route (EGP).
• unicast (direct)—Unicast route (directly connected).
• unicast—Other unicast route (such as unicast static route).
• mbgp—MBGP route.
• multicast static—Static multicast route.
Route selection rule
Rule for RPF route selection, which can be based on the preference of
the routing protocol or based on the longest match on the destination
address.
Load splitting rule Whether the load splitting rule is enabled.
Related commands
• display multicast forwarding-table
• display multicast routing-table
ip rpf-route-static
Use ip rpf-route-static to configure a static multicast route.
Use undo ip rpf-route-static to delete a static multicast route from the static multicast routing table.
Syntax
ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ] [ route-policy
policy-name ] { rpf-nbr-address | interface-type interface-number } [ preference preference ] [ order
order-number ]
undo ip rpf-route-static source-address { mask | mask-length } [ protocol [ process-id ] ] [ route-policy
policy-name ]
Default
No static multicast route is configured.