HP VPN Firewall Appliances Network Management Command Reference

33
Interface Link Cause
Loop1 ADM Administratively
Table 8 Command output
Field Descri
p
tion
current state
Physical state of the interface:
• up.
• administratively down.
Line protocol current state
State of the data link layer protocol: up (spoofing). Spoofing
refers to the spoofing attribute of the interface. When the network
layer protocol state of the interface is displayed as up, the
corresponding link might not exist, or the corresponding link is
non-permanent and established on demand.
Description Description of the interface.
The Maximum Transmit Unit MTU of the interface.
Internet protocol processing
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary).
Physical is loopback The physical type of the interface is loopback.
Last clearing of counters
Last time when statistics on the logical interface were cleared by
using the reset counters interface command.
If the statistics have never been cleared since the device started,
this field displays Never.
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average input rate over the last 300 seconds in Bps, bps, and
pps.
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average output rate over the last 300 seconds in Bps, bps, and
pps.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of input packets on the interface
and the number of dropped packets.
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of output packets on the interface
and the number of dropped packets.
The brief information of interface(s) under
route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby -
standby
Link status of the interface:
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is operating as a backup interface. To see
the primary interface, use the display standby state command
in High Availability Command Reference.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP,
but its link is an on-demand link or not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut down. To
recover its physical state, use the undo shutdown command.