HP VPN Firewall Appliances Network Management Command Reference

567
Related commands
display multicast forwarding-table
multicast load-splitting
Use multicast load-splitting to enable load splitting of multicast traffic.
Use undo multicast load-splitting to disable load splitting of multicast traffic.
Syntax
multicast load-splitting { source | source-group }
undo multicast load-splitting
Default
Load splitting of multicast traffic is disabled.
Views
System view
Default command level
2: System level
Parameters
source: Specifies load splitting on a per-source basis.
source-group: Specifies load splitting both on a per-source basis and a per-group basis.
Usage guidelines
This command does not take effect in BIDIR-PIM.
Examples
# Enable per-source load splitting of multicast traffic on the public network.
<Sysname> system-view
[Sysname] multicast load-splitting source
multicast longest-match
Use multicast longest-match to configure the device to select the RPF route based on the longest match
principle, namely, to select the route with the longest mask as the RPF route.
Use undo multicast longest-match to restore the default.
Syntax
multicast longest-match
undo multicast longest-match
Default
The device selects the route with the highest priority as the RPF route.
Views
System view