HP VPN Firewall Appliances Network Management Command Reference

568
Default command level
2: System level
Examples
# Configure the device to select the RPF route based on the longest match principle on the public
network.
<Sysname> system-view
[Sysname] multicast longest-match
multicast routing-enable
Use multicast routing-enable to enable IP multicast routing.
Use undo multicast routing-enable to disable IP multicast routing.
Syntax
multicast routing-enable
undo multicast routing-enable
Default
IP multicast routing is disabled.
Views
System view
Default command level
2: System level
Usage guidelines
You must enable IP multicast routing before you can execute other Layer 3 multicast commands.
The device does not forward any multicast packets before IP multicast routing is enabled.
Examples
# Enable IP multicast routing on the public network.
<Sysname> system-view
[Sysname] multicast routing-enable
reset multicast forwarding-table
Use reset multicast forwarding-table to clear the multicast forwarding table.
Syntax
reset multicast forwarding-table { { source-address [ mask { mask | mask-length } ] | group-address
[ mask { mask | mask-length } ] | incoming-interface { interface-type interface-number | register } } * |
all }
Views
User view
Default command level
2: System level