HP VPN Firewall Appliances Network Management Command Reference

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module

651

652

653

654

655

656

657

658

659

660

630

Syntax

display pim routing-table [ group-address [ mask { mask-length | mask } ] | source-address [ mask

{ mask-length | mask } ] | incoming-interface [ interface-type interface-number | register ] |

outgoing-interface { include | exclude | match } { interface-type interface-number | register } | mode

mode-type | flags flag-value | fsm ] * [ | { begin | exclude | include } regular-expression ]

Views

Any view

Default command level

1: Monitor level

Parameters

group-address: Specifies a multicast group address, in the range of 224.0.0.0 to 239.255.255.255.

source-address: Specifies a multicast source address.

mask: Specifies the mask of the multicast group/source address, 255.255.255.255 by default.

mask-length: Specifies the mask length of the multicast group/source address, in the range of 0 to 32.

The system default is 32.

incoming-interface: Specifies an incoming interface.

interface-type interface-number: Specifies an interface by its type and number.

outgoing-interface: Specifies an outgoing interface.

include: Specifies an interface in the outgoing interface list.

exclude: Specifies an interface not in the outgoing interface list.

match: Specifies an interface that only exists in the outgoing interface list.

mode mode-type: Specifies a PIM mode, where mode-type can have the following values:

• dm: Specifies PIM-DM.

• sm: Specifies PIM-SM.

• ssm: Specifies PIM-SSM.

flags flag-value: Specifies a flag. The values of flag-value and their meanings are as follows:

• 2msdp: Specifies PIM routing entries to be contained in the next SA message to notify an MSDP

peer.

• act: Specifies PIM routing entries that have been used for routing data.

• del: Specifies PIM routing entries scheduled to be deleted.

• exprune: Specifies PIM routing entries containing outgoing interfaces pruned by other multicast

routing protocols.

• ext: Specifies PIM routing entries containing outgoing interfaces provided by other multicast routing

protocols.

• loc: Specifies PIM routing entries on the devices that directly connect to the same subnet as the

multicast source.

• msdp: Specifies PIM routing entries learned from MSDP SA messages.

• niif: Specifies PIM routing entries containing unknown incoming interfaces.