HP VPN Firewall Appliances Network Management Command Reference

651
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a join/prune interval in seconds. The value ranges from 1 to 2147483647.
Examples
# Set the join/prune interval to 80 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim timer join-prune 80
Related commands
timer join-prune
pim triggered-hello-delay
Use pim triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay interval
undo pim triggered-hello-delay
Default
The maximum delay between hello messages is 5 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies the maximum delay in seconds between hello messages. The value ranges from 1 to
60.
Examples
# Set the maximum delay between hello messages to 3 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim triggered-hello-delay 3
probe-interval (PIM view)
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.