HP VPN Firewall Appliances Network Management Command Reference

657
Default
The device switches to the SPT immediately after it receives the first multicast packet.
Views
Public network PIM view
Default command level
2: System level
Parameters
infinity: Disables switchover to SPT.
group-policy acl-number: Specifies a basic ACL, in the range of 2000 to 2999. If you do not include this
option in your command, the configuration applies to all multicast groups.
order order-value: Specifies the order of the ACL in the group-policy list, where order-value has an
effective range of 1 to (the largest order value in the existing group-policy list + 1), but the value range
should not include the original order value of the ACL in the group-policy list. If you have assigned an
order-value to a certain ACL, do not specify the same order-value for another ACL. Otherwise the system
will give error information. If you do not specify an order-value, the order value of the ACL will remain the
same in the group-policy list.
Usage guidelines
To adjust the order of an existing ACL in the group-policy list, you can use the acl-number argument to
specify this ACL and set its order-value. This inserts the ACL to the position of order-value in the
group-policy list. The order of the other existing ACLs in the group-policy list remains unchanged.
To use an ACL that does not exist in the group-policy list, you can use the acl-number argument to specify
an ACL and set its order-value. This inserts the ACL to the position of order-value in the group-policy list.
If you do not include the order order-value option in your command, the ACL is appended to the end of
the group-policy list.
If you use this command multiple times on the same multicast group, the first traffic rate configuration
matched in sequence takes effect.
Examples
# Disable the switchover to SPT on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] spt-switch-threshold infinity
ssm-policy (PIM view)
Use ssm-policy to configure the SSM multicast group range.
Use undo ssm-policy to restore the default.
Syntax
ssm-policy acl-number
undo ssm-policy
Default
The SSM group range is 232.0.0.0/8.