HP VPN Firewall Appliances Network Management Command Reference

659
• state-refresh-rate-limit
• state-refresh-ttl
state-refresh-rate-limit (PIM view)
Use state-refresh-rate-limit to configure the time that the router waits before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit interval
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it receives a new state refresh message.
Views
Public network PIM view
Default command level
2: System level
Parameters
interval: Specifies a time that the device waits before receiving a new refresh message. The value ranges
from 1 to 65535 seconds.
Examples
# On the public network, configure the device to wait 45 seconds before it receives a new state refresh
message.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45
Related commands
• pim state-refresh-capable
• state-refresh-interval
• state-refresh-ttl
state-refresh-ttl
Use state-refresh-ttl to configure the TTL value for state refresh messages.
Use undo state-refresh-ttl to restore the default.
Syntax
state-refresh-ttl ttl-value
undo state-refresh-ttl
Default
The TTL value of state refresh messages is 255.