HP VPN Firewall Appliances Network Management Command Reference

677
Default command level
2: System level
Parameters
peer-address: Specifies an MSDP peer.
Usage guidelines
Before you can enable the device to send SA requests, you must disable the SA message cache
mechanism.
Examples
# Disable the SA message cache mechanism on the public network, and enable the router to send an SA
request message to the MSDP peer 125.10.7.6 after receiving a new join message.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] undo cache-sa-enable
[Sysname-msdp] peer 125.10.7.6 request-sa-enable
Related commands
cache-sa-enable
peer sa-cache-maximum
Use peer sa-cache-maximum to configure the maximum number of (S, G) entries learned from the
specified MSDP peer that the device can cache.
Use undo peer sa-cache-maximum to restore the default.
Syntax
peer peer-address sa-cache-maximum sa-limit
undo peer peer-address sa-cache-maximum
Default
The maximum number depends on the device model. For more information, see the following table.
Views
Public network MSDP view
Default command level
2: System level
Parameters
peer-address: Specifies an MSDP peer.
sa-limit: Specifies the maximum number of (S, G) entries that the device can cache.
The following matrix shows the value range and default value for the sa-limit argument on different
firewalls and firewall modules:
Hardware Value ran
g
e Default value
F1000-A-EI/F1000-S-EI 1 to 8192 8192
F1000-E 1 to 8192 8192