HP VPN Firewall Appliances Network Management Command Reference

721
• If the second method is used, the corresponding VLAN interface must exist and the port specified by
port-type port-number must belong to the VLAN specified by vlan-id. After the static neighbor entry
is configured, the device associates the VLAN interface with the IPv6 address to uniquely identify
the static neighbor entry and the entry is in REACH state.
To remove a static neighbor entry, you only need to specify the corresponding VLAN interface and the
neighbor address.
Examples
# Configure a static neighbor entry for Layer 3 interface GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 interface gigabitethernet 0/1
Related commands
display ipv6 neighbors
ipv6 neighbor stale-aging
Use ipv6 neighbor stale-aging to set the age timer for ND entries in stale state.
Use undo ipv6 neighbor stale-aging to restore the default.
Syntax
ipv6 neighbor stale-aging aging-time
undo ipv6 neighbor stale-aging
Default
The age timer for ND entries in stale state is four hours.
Views
System view
Default command level
2: System level
Parameters
aging-time: Aging timer for ND entries in stale state, in the range of 1 to 24 hours.
Examples
# Set the aging timer for ND entries in stale state to 2 hours.
<Sysname> system-view
[Sysname] ipv6 neighbor stale-aging 2
ipv6 neighbors max-learning-num
Use ipv6 neighbors max-learning-num to configure the maximum number of neighbors that can be
dynamically learned on the interface.
Use undo ipv6 neighbors max-learning-num to restore the default.
Syntax
ipv6 neighbors max-learning-num number