HP VPN Firewall Appliances Network Management Command Reference

796
Usage guidelines
If no VPN is specified, the RIPng process is enabled for the public network.
The specified VPN instance must have been created with the ip vpn-instance command.
Before configuring global RIPng parameters, you must create a RIPng process. This requirement does not
apply to interface RIPng parameter configuration.
After you disable a RIPng process, the RIPng parameters on interface running the process also become
ineffective.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100
# Create RIPng process 101 and bind it to VPN instance vpn101.
<Sysname> system-view
[Sysname] ripng 101 vpn-instance vpn101
ripng default-route
Use ripng default-route to advertise a default route with the specified routing metric to a RIPng neighbor.
Use undo ripng default-route to stop advertising or forwarding the default route.
Syntax
ripng default-route { only | originate } [ cost cost ]
undo ripng default-route
Default
A RIPng process does not advertise any default route.
Views
Interface view
Default command level
2: System level
Parameters
only: Indicates that only the IPv6 default route (::/0) is advertised through the interface.
originate: Indicates that the IPv6 default route (::/0) is advertised without suppressing other routes.
cost: Metric of the advertised default route, in the range of 1 to 15, with a default value of 1.
Usage guidelines
After you execute this command, the generated RIPng default route is advertised in a route update over
the specified interface. This IPv6 default route is advertised without considering whether it already exists
in the local IPv6 routing table.