HP VPN Firewall Appliances Network Management Command Reference

62
Default
The PVID of a hybrid port is VLAN 1.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to permit the packets from the
PVID to pass through.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Examples
# Configure VLAN 100 as the PVID of the hybrid port GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] vlan 100
[Sysname-vlan100] quit
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] port link-type hybrid
[Sysname-GigabitEthernet0/1] port hybrid pvid vlan 100
# Configure VLAN 100 as the PVID of the hybrid Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid pvid vlan 100
Related commands
• port hybrid vlan
• port link-type
port hybrid vlan
Use port hybrid vlan to assign the hybrid ports to the specified VLANs.