HP VPN Firewall Appliances Network Management Command Reference

869
Maximum allowed prefix number: 4294967295
Threshold: 75%
Configured hold timer value: 180
Keepalive timer value: 60
Minimum time between advertisement runs is 15 seconds
Peer Preferred Value: 0
No routing policy is configured
BFD: Enabled
Members:
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
2001::1 100 0 0 0 0 00:00:07 Idle
Table 197 Command output
Field Descri
p
tion
BGP peer-group Name of the peer group.
Remote AS
AS number of the peer group.
If the peer group AS number has been specified with the peer
ipv6-address as-number as-number command, the specified AS
number is displayed in this field. Otherwise, a "Remote AS
number not specified" prompt is displayed.
Type
Types of the peer group:
• internal—IBGP peer group.
• external—EBGP peer group.
Maximum allowed prefix number Maximum allowed prefix number.
Threshold Threshold value.
Configured hold timer value Holdtime.
Keepalive timer value Keepalive interval.
Minimum time between advertisement runs Minimum interval between advertisements.
Route refresh capability has been enabled The route-refresh capability has been enabled.
ORF advertise capability based on prefix
(type 64):
The BGP peer supports the ORF capability based on IP prefix.
The capability value is 64.
Local: both
The local BGP router supports both the ORF sending and
receiving capabilities.
Negotiated: send
Negotiation result: The local BGP router can send Router-refresh
messages carrying the ORF information, and the peer can
receive Router-refresh messages carrying the ORF information.
If receive is displayed, the local BGP router can receive
Router-refresh messages carrying the ORF information, and the
peer can send Router-refresh messages carrying the ORF
information. This field is not displayed if neither the send nor the
receive capability is supported.)
Peer Preferred Value Preferred value of the routes from the peer.
IPsec policy name IPsec policy applied to the peer group.
SPI SPI of the IPsec policy.