HP VPN Firewall Appliances Network Management Command Reference

924
reflect between-clients (IPv6 address family view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
IPv6 address family view
Default command level
2: System level
Usage guidelines
After a route reflector is configured, it reflects routes between clients. If the clients are fully meshed, HP
recommends that you disable route reflection on the route reflector to reduce costs.
Examples
# Enable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id
reflector cluster-id (IPv6 address family view)
Use reflector cluster-id to configure the cluster ID of the route reflector.
Use undo reflector cluster-id to remove the configured cluster ID.
Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
Default
A route reflector uses its router ID as the cluster ID.
Views
IPv6 address family view
Default command level
2: System level