HP VPN Firewall Appliances Network Management Command Reference

941
IPv6 policy-based routing commands
apply default output-interface
Use apply default output-interface to set a default output interface.
Use undo apply default output-interface to remove the configuration.
Syntax
apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
Views
IPv6 policy node view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
This command only applies to packets that do not find a match in the routing table. You can specify up
to five default output interfaces for per-flow load balancing.
With an interface specified, the undo apply default output-interface command removes the specified
default output interface.
Without any interface specified, the undo apply default output-interface command removes all default
output interfaces.
Examples
# Set GigabitEthernet 0/1 as the default output interface.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply default output-interface gigabitethernet 0/1
apply ipv6-address default next-hop
Use apply ipv6-address default next-hop to set a default next hop.
Use undo apply ipv6-address default next-hop to remove the default next hop.
Syntax
apply ipv6-address default next-hop ipv6-address
undo apply ipv6-address default next-hop [ ipv6-address ]
Views
IPv6 policy node view