HP VPN Firewall Appliances Network Management Command Reference

942
Default command level
2: System level
Parameters
ipv6-address: Specifies the default next hop IPv6 address.
Usage guidelines
This command only applies to packets not finding a match in the routing table.
You can specify up to five default next hops for per-flow load balancing.
With a next hop specified, the undo apply ipv6-address default next-hop command removes the
specified default next hop.
Without any next hop specified, the undo apply ipv6-address default next-hop command removes all
default next hops.
Examples
# Set a default next hop of 1::1 for IPv6 packets.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply ipv6-address default next-hop 1::1
apply ipv6-address next-hop
Use apply ipv6-address next-hop to set a next hop.
Use undo apply ipv6-address next-hop to remove the next hop.
Syntax
apply ipv6-address next-hop ipv6-address
undo apply ipv6-address next-hop [ ipv6-address ]
Views
IPv6 policy node view
Default command level
2: System level
Parameters
ipv6-address: Specifies the next-hop IPv6 address.
Usage guidelines
The next hop must be adjacent to the device.
You can specify up to five next hops for per-flow load balancing.
With a next hop specified, the undo apply ipv6-address next-hop command removes the specified next
hop.
With no next hop specified, the undo apply ipv6-address next-hop command removes all next hops.
Examples
# Set a next hop of 1::1 for IPv6 packets.
<Sysname> system-view