HP VPN Firewall Appliances Network Management Command Reference

943
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply ipv6-address next-hop 1::1
apply ipv6-precedence
Use apply ipv6-precedence to set a preference or preference type for IPv6 packets.
Use undo apply ipv6-precedence to remove the configuration.
Syntax
apply ipv6-precedence { type | value }
undo apply ipv6-precedence
Views
IPv6 policy node view
Default command level
2: System level
Parameters
type: Sets a preference type.
value: Sets a preference value from 0 to 7 (inclusive). Each value corresponds to a preference type, as
shown in Table 213.
Table 213 IPv6 preferences and the corresponding
types
Preference value
Preference t
yp
e
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network
Examples
# Set a preference of 5 (critical).
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply ipv6-precedence critical
apply output-interface
Use apply output-interface to set output interfaces for IPv6 packets.
Use undo apply output-interface to remove the configuration.