HP VPN Firewall Appliances Network Management Command Reference

950
Views
System view
Default command level
2: System level
Parameters
policy-name: Specifies the policy name, a string of 1 to 19 characters.
Usage guidelines
You can configure only one IPv6 policy for local PBR. If you perform this command multiple times, only
the last specified policy takes effect.
Local PBR is used to route locally generated packets. Do not configure IPv6 local PBR unless required.
Examples
# Configure IPv6 local PBR based on policy AAA.
<Sysname> system-view
[Sysname] ipv6 local policy-based-route AAA
ipv6 policy-based-route (interface view)
Use ipv6 policy-based-route to configure IPv6 PBR by applying a policy on the interface.
Use undo ipv6 policy-based-route to remove the configuration.
Syntax
ipv6 policy-based-route policy-name
undo ipv6 policy-based-route
Default
No IPv6 policy is applied on an interface.
Views
Interface view
Default command level
2: System level
Parameters
policy-name: Specifies the policy name, a string of 1 to 19 characters.
Usage guidelines
You can apply only one policy on an interface. If you perform this command multiple times, only the last
specified policy takes effect.
Examples
# Apply IPv6 policy AAA on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ipv6 policy-based-route AAA